Official StoreDrawer Front Installation Clamps Set

One click replaces ten minutes of setup

Traditional C-clamps need hand-tightening and often twist under pressure. These lock with one decisive click — both sides grip equally, so the drawer hangs true.

No extra hands, no fumbling. Position, lock, drill.

21–50 mm span covers nearly every drawer

The adjustable width range handles thin veneered fronts all the way up to thick solid wood — one set replaces three older clamps with different ranges.

Over 90% of cabinetry scenarios fit within this range, so you're not chasing specialty gear.

Bow-shaped design grips from both sides

The two bow-shaped clamps apply equal pressure on top and bottom of the drawer front. No twist, no rotation, no hour-long coaxing it into square.

Paired with two large adjustable clips for extra reach and flexibility on wider or oddly-shaped pieces.

Speed and consistency across your whole run

Install ten drawers in a morning. Lock the front, position it, mark and drill all four holes, move to the next one. Every single drawer is identical because the clamps hold the same reference every time.

Reinforced materials survive hundreds of installs without wear or play creeping in.

1. Position the clamp

Set the drawer front in the frame and position the clamp around it, adjusting the width to grip snugly.

2. Click lock

Press the one-click locking button to lock both sides of the clamp simultaneously — instant, equal pressure.

3. Mark and drill

Mark your hole locations and drill. All four hinges will land in identical spots every time.